Non-Skid Kit for Omni Table

Non-Skid Kit for Omni Table - COMPLETE KIT 

Replace the worn and tattered non-skid on your Omni table with this complete non-skid kit. This kit includes 6 squares of non-skid for the foot kickers and 2 strips of non-skid for the cervical elevation pedal.

Each piece of the non-skid kit is oversized to avoid bad placement. Each piece of non-skid has an adhesive backing.

This non-skid kit is easy to install. Just follow the directions below.

1. Remove old non-skid from table. Do this by peeling off the old non-skid. A razor blade may come in handy as sometimes the old non-skid can tear.
2. Place new non-skid on table. Remove the backing and place the new non-skid on the part you are working on. The new non-skid should hang over 3 sides of the foot kickers and 2 sides of the cervical elevation pedal.
3. Trim excess from new non-skid. Trim the excess non-skid that is hanging over the sides using a razor blade. Just place the side of the blade against the metal and trim away.

You should now have a clean looking table with brand new non-skid.